149
set management remote-access telnet-port [ 1 - 65534 ]
Specifies the port number for remote access Telnet (CLI) communication with the NVG599 device. Because
port numbers in the range 0-1024 are used by other protocols, you should use numbers in the range 1025-
65534 when assigning new port numbers to the NVG599 Telnet configuration interface. A setting of 0 (zero)
will turn the server off. Defaults to port 0.
set management remote-access telnet-idle-timeout [ 1...120 ]
Specifies a timeout period of inactivity for remote Telnet access to the NVG599 device, after which a user must
log in to the device. Default is 5 minutes for Telnet.
set management remote-access telnet-total-timeout [ 1...120 ]
Specifies a total timeout period of inactivity for remote Telnet access to the NVG599 device, after which a user
must log in to the device. Default is 20 minutes for Telnet.
set management remote-access telnet-max-clients number
Specifies the maximum number of client sessions for remote Telnet access management. Defaults to 4.
set management remote-access ssh-port [ 1 - 65534 ]
Specifies the port number for secure shell (SSH) communication with the NVG599. Defaults to port 22.
set management remote-access ssh-idle-timeout [ 1...120 ]
Specifies a timeout period of inactivity for remote secure shell (SSH) access to the NVG599 device, after which
a user must log in to the device. Default is 5 minutes for SSH.
set management remote-access ssh-total-timeout [ 1...120 ]
Specifies a total timeout period of inactivity for remote secure shell (SSH) access to the NVG599 device, after
which a user must log in to the device. Default is 20 minutes for SSH.
set management remote-access ssh-max-clients number
Specifies the maximum number of client sessions for remote secure shell (SSH) access management. Defaults
to 4.
set management lan-redirect enable [ off | on ]
If set to on and a WAN failure condition is detected, the LAN client's browser is redirected to a Web page of
failure and Help text information. The redirect will only occur once, as the Web UI maintains a state variable to
determine whether the redirect has occurred; to continually redirect would block the user from reconfiguring
the router.
set management lan-redirect missing-filter-notify [ on | off ]
If set to on and a missing filter on the line is detected, the LAN client's browser is redirected to a Web page of
failure and Help text information. The redirect will only occur once, as the Web UI maintains a state variable to
determine whether the redirect has occurred; to continually redirect would block the user from reconfiguring
the router.
To Next Page
Loading...
