115
show status
Displays the current status of an NVG599 device, the device's hardware and software revision levels, a
summary of errors encountered, and the length of time the device has been running since it was last restarted.
Identical to the status command.
show summary
Displays a summary of WAN, LAN, and gateway information.
show vlan
Displays detail of VLAN status and statistics.
show wireless [ all ]
Shows wireless status and statistics.
show wireless clients [ MAC_address ]
Displays details on connected clients, or more details on a particular client if the MAC address is added as an
argument.
show voip
Displays VoIP call statistics.
show voiplog
Displays VoIP event logs.
telnet [ hostname | ip_address ] [ port ]
Lets you open a Telnet connection to the specified host through your NVG599 device.
The hostname argument is the name of the device to which you want to connect, for example, telnet
ftp.arris.com.
The ip_address argument is the IP address, in dotted decimal notation, of the device to which you want to
connect.
The port argument is the number of the port over which you want to open a Telnet session.
traceroute ( ip_address | hostname )
Traces the routing path to an IP destination.
upload [ server_address ] [ filename ] [ confirm ]
Copies the current configuration settings of the NVG599 to a TFTP (Trivial File Transfer Protocol) server. The
TFTP server must be accessible on your Ethernet network. The server_address argument identifies the IP
address of the TFTP server on which you want to store the NVG599 settings. The filename argument identifies
the path and name of the configuration file on the TFTP server. If you include the optional confirm keyword,
you will not be prompted to confirm whether or not you want to perform the operation.
view config
Dumps the NVG599 device’s configuration just as the view command does in Configure mode.
To Next Page
