153
set physical dsl atm vcc 2 vci [ 32 - 65535 ]
Sets the virtual channel identifier (VCI) for the circuit. Default is 35.
set physical dsl atm vcc vcc_num tx-queue queue_name
Attaches the egress queue template to the ATM VC when the queue type is egress.
set physical dsl atm vcc vcc_num rx-queue queue_name
Attaches the ingress queue to the ATM VC when the queue type is ingress.
set physical dsl ptm datapath [ phy0fast | phy0interleaved ]
Sets the ATM datapath, Fast Path or Interleaved. Default is phy0fast.
set physical dsl ptm priority [ low | high ]
Sets the packet transfer mode (PTM) priority. Default is low.
set physical dsl ptm tx-queue queue_name
Attaches the egress queue template to the PTM interface when the queue type is egress.
set physical dsl ptm rx-queue queue_name
Attaches the ingress queue to the PTM interface when the queue type is ingress.
set physical dsl atm vcc 1 auto-vpi-vci [ on | off ]
Turns automatic VPI/VCI detection on or off. If you leave the default on, the device will try a series of VPI/VCI
pairs that are commonly used by service providers. When one pair succeeds, the device will use this one for
future connections.
set physical dsl atm vcc 1 vpi-vci-list vpi_vci_pairs
Specifies the series of VPI/VCI pairs that the device will use to attempt a connection. The default set ("0/35 8/35
0/43 0/51 0/59 8/43 8/51 8/59") can be changed.
set physical dsl atm vcc 1 qos enable [ off | on ]
Turns QoS off or on on the virtual circuit. Default is off.
set physical dsl power-save enable [ off | on ]
Turns power saving mode off or on. Default is off.
To Next Page
