155
Wireless Interfaces
set physical wireless enable [ on | off ]
Enables or disables the wireless capability for supported Wi-Fi devices. Default is on.
set physical wireless standard [ bg | b-only | g-only | bgn | n-only | an | a-only ]
Sets and locks the NVG599 into the wireless transmission mode you want: bg, b-only, g-only, bgn, n-only, an,
or a-only. For compatibility with clients using 802.11b (up to 11 Mbps transmission), 802.11g (up to 20+
Mbps), 802.11a (up to 54 Mbit/s using the 5 GHz band), or 802.11n (from 54 Mbit/s to 600 Mbit/s with the use
of four spatial streams at a channel width of 40 MHz), select b/g/n. To limit your wireless LAN to one mode or
the other, select g-only, n-only, a-only, or b-only, or some combination that applies to your setup. Default is
bgn.
set physical wireless auto-channel [ off | on ]
Turns auto-channel selection on or off.
set physical wireless bandwidth [ narrow | wide ]
Specifies whether the Wi-Fi channel is narrow or wide band. Default is narrow in compliance with FCC
requirements.
set physical wireless default-channel [ 1... 11 ]
(1 through 11, for North America) on which the network will broadcast. This is a frequency range within the
2.4 Ghz band. Channel selection can have a significant impact on performance, depending on other wireless
activity close to this router. Channel selection is not necessary at the client computers; the clients will scan the
available channels seeking access points using the same SSID as the client. Defaults to 6.
set physical wireless power [ 1 - 100 ]
Sets some value lower than 100 percent transmit power if your NVG599 device is located close to other Wi-Fi
devices and causes interference. Defaults to 100 (percent).
set physical wireless mul2uni [ off | on ]
Turns wireless “many-to-one” packet scheduling off or on. Default is off.
set physical wireless ssid 1 enable [ on | off ]
Enables or disables the first (default) Wi-Fi SSID.
set physical wireless ssid 1 name name
Specifies a name for the first Wi-Fi SSID. Defaults to a unique value per router of the form “ATTxxx”.
set physical wireless ssid 1 access-type [ none | allow | deny ]
Specifies the type of address list for defining MAC address filtering. If set to allow, only hosts with the specified
addresses will be permitted to join the WLAN of the specified SSID. If set to deny, any hosts except those with
the specified addresses will be permitted to join the specified SSID. Default is none.
To Next Page
