Administrator’s Handbook
176
set system syslog facility [ local0 ... local7 ]
Specifies the local facility number that Syslog messages are sent to (range: local0 - local7, default: local0).
set system syslog level [ 0 ... 7 ]
Sets the severity level of Syslog messages the NVG599 will send to the Syslog server. Each severity level
includes all higher-level messages (e.g; a level of 2 [Critical] will also send Alert and Emergency messages). The
severity levels are arranged and enumerated as follows:
0 : Emergency
1 : Alert
2 : Critical
3 : Error
4 : Warning
5 : Notice (default)
6 : Info
7 : Debug
set system syslog log-system [ on | off ]
Enables or disables the generation of system log messages for the Syslog server. If the Syslog function is
enabled, system log is enabled (on) by default.
set system syslog log-firewall [ on | off ]
Enables or disables the delivery of firewall log messages to the Syslog server. Firewall log is disabled by default.
set system syslog log-igmp [ on | off ]
Enables or disables the delivery of IGMP log messages to the Syslog server. The IGMP log is disabled by default.
set system syslog log-voice [ on | off ]
Enables or disables the generation of voice log messages for the Syslog server. Voice log is disabled by default.
set system voice-check enable [ off | on ]
When this is set to on, and a voice call is in progress when a software update is scheduled, the software update
is deferred for the voice-check interval until the call is completed, that is, the call state becomes “idle.” If set to
off, and a voice call is in progress when an update is scheduled, the call is torn down. The default is on.
set system voice-check interval [ 60 - 86400 ]
Specifies the interval in seconds for the device to wait before attempting a software update, when a software
update is scheduled but a voice call is in progress, when voice-check enable is set to on. The default is 300 (5
minutes).
set system voice-check max-time [ 300 - 604800 ]
Specifies the maximum time in seconds for the device to continue to attempt a scheduled software update if a
voice call is in progress and voice-check enable is set to on. The default is 3600 (1 hour).
To Next Page
