Artec LEO - Pause and Resume Scan; Addition; New Scan in Project

Artec Leo
2.2.2 Pause and Resume Scan
While scanning, you may need to pause capturing for various reasons. Press the
start/stop button
3/29/23, 5:41 PM
red_but.svg
file:///C:/Users/admin/ld/_build/latex/red_but.svg
1/1
to this end.
There are two ways to resume your scan:
• Addition
• New Scan in Project
2.2.2.1 Addition
If you want to continue scanning the same scene, create a new addition to a scan.
A successfully created addition will be aligned with the previously captured 3D
data.
To continue scanning in the same scan, follow the procedure covered in Resume
Scanning.
2.2.2.2 New Scan in Project
If you intend to add a new scan that relates to the project, but either of the cases
below is applicable, consider adding a new scan:
• Scanning scene has changed.
• You ipped the object.
To add a new scan,
1. Open the required project.
2. Tap Add scan.
3. Point the scanner at the object and press the start/stop button
3/29/23, 5:41 PM
red_but.svg
file:///C:/Users/admin/ld/_build/latex/red_but.svg
1/1
.
18 Chapter 2. Scan