Artec LEO - Storage Encryption

Artec Leo
4.2.3.1 Storage Encryption
Storage encryption is a way to restrict access to Leo’s storage by using a password.
Once the storage is encrypted, no one will be able to use the Leo scanner without
knowing the password.
Warning: If the password for the Leo’s storage is lost or forgotten, it can-
not be restored. In this case, to reset your password or disable the storage
encryption, you will need to format the storage and erase all your data.
You can change the password for the Leo’s storage at any time without aect-
ing your data. However, this would require entering the current password (see
Changing encryption password).
Note: By default, the storage encryption is disabled.
The status of storage encryption can be one of the following:
Encryption status Description
Disabled The storage encryption is disabled.
Enabled The storage encryption is enabled, the device is pass-
word protected.
Attention: Both enabling and disabling the storage encryption require for-
matting the Leo’s storage, which means the loss of all stored data.
To enable the storage encryption, follow these steps:
1. Select Settings → Scanner → Advanced → Storage Encryption.
2. Tap Restart and encrypt storage in the lower-right corner.
3. Create and enter a password for accessing the storage and then conrm it
on the next screen.
4. On the screen that appears, enter “Erase all” to conrm the erasure of all
stored data and then tap Start encryption.
4.2. Scanner 57