Artec LEO - Process Project in Artec Studio; Autopilot

Artec Leo
2. Remove the microSD card from Leo.
3. Insert the card into a microSD reader connected to the computer with the
installed Artec Studio.
4. Copy les to this computer.
5. Open Artec Studio.
6. Select File → Import → Leo project.
7. Navigate the folder tree to the required project.
Important: HD data is not saved in the project copy on the microSD card.
In order to save HD data on the microSD card, the projects must be encrypted
(Encrypt Projects to Export).
3.11 Process Project in Artec Studio
Once you import the project, process it as Artec Studio Manual suggests.
Important: Double check that the Current scanner type is set as Artec Leo in
Artec Studio settings (Scan → Algorithm settings).
3.11.1 Autopilot
One of the convenient ways to process the scanned data from Leo is through using
Autopilot. As soon as you import a Leo scan in Artec Studio, select Autopilot in
the left toolbar.
3.11. Process Project in Artec Studio 41