Artec Leo
4.1 Turn O
Note: A single press of the power button on the scanner housing works as a
Back button, i.e. it returns a user to the previous screen or state.
To turn o Leo scanner, follow the steps:
1. Press the power button as many
times as needed for the Project
screen to appear. Then press-
the power button once again.
1. Select Settings → Scanner →
General → Shut down.
2. Tap Shut down in the dialog that
has appeared.
Important: A long press of the power button starts a hard reset. Use a hard
reset sparingly, only if it is absolutely necessary, since it may lead to incorrect
termination of the system processes.
4.2 Scanner
4.2.1 General
The General tab (shown in the gure) contains the following elds:
44 Chapter 4. Settings
To Next Page
Loading...
