Artec LEO - Calibration; Leo Recalibration

Artec Leo
in the status bar.
To set up your own wired network with Leo, you need to
• Connect the scanner via an Ethernet cable to a computer with Artec Studio
software.
• Select Settings → Network → Connect to Leo.
• Turn on the Wired (DHCP server) toggle for the computer to automatically
obtain an IP address from Leo via DHCP.
• Congure the computer to automatically obtain an IP address via DHCP in
the network adapter properties.
After these steps, you can interact with the scanner using Artec Studio software.
Warning: Be careful when using Leo as a DHCP server. If you connect to a
network in this mode with another DHCP server, it may result in an unwanted
network conguration.
To set up your own wireless network with Leo, you need to
• Select Settings → Network → Connect to Leo.
• Specify Hotspot name and Hotspot password for your future connection.
• Turn on the Wireless (Hotspot) toggle.
• Connect your computer with Artec Studio software via Wi-Fi to the newly
created hotspot.
After these steps, the computer and scanner will be on the same network and ready
to communicate.
Note: Connecting to existing networks (both wired and wireless) will allow you
to access the Internet (if congured) to update the software, communicate with
my.artec3d.com and download projects. Networks created by Leo (as a DHCP
server or hotspot) allow only le transfer.
62 Chapter 4. Settings