iHP Manual 84 | P a g e
Configuration
This section discusses user configurable parameters of iHP rack (ISOCOMM configuration) and iHP module.
Configuration settings can be accomplished using a computer to connect to the iHP unit.
5.1 ISOCOMM User Configurable Parameters
iHP rack configuration can be updated using Ethernet communication only. iHP racks have a built-in WebTool
to edit ISOCOMM configuration. The configuration can be changed using an internet browser. Recommended
internet browser is Google Chrome.
ISOCOMM WebTool is composed of different section. Each section will be discussed on succeeding pages.
Home section contains summary of the iHP rack’s network setting and the rack’s firmware versions,
and the iHP modules connected to the iHP rack with the module’s respective firmware version.
Network section contains communication and network configuration.
Rack section contains iHP rack configuration.
Module section contains commands necessary for grouping modules.
Firmware section contains information to perform a firmware update.
Maintenance section contains information to initiate System Reset.
To access the ISOCOMM WebTool, open the web browser and type the iHP rack IP address to access the
WebTool. The home page will be displayed.
To Next Page
Loading...