Arturia mini v - Setting the Modulation Amount of a Motion Curve; The Parameters Available for the Motion Recorder

ARTURIA – Mini V – USER’S MANUAL
53
Steps appears on the motion curve
Those steps on the motion curve can bring some interesting rhythmic grooves or some sample and hold effect if
you use the Square tool available on the “Edit” interface. (See below for more details about the edit tools)
5.7.6 Setting the modulation amount of a motion curve
You can set the output modulation amount for each motion curves to refine the
modulation results as you wish.
 Select the desired motion track thanks to the “ ” button.
 Click on the amount potentiometer (labeled “AMT”) situated under the Motion
Recorder main screen and set the desired amount of modulation.
Click on the amount potentiometer
5.7.7 The parameters available for the Motion Recorder
The parameters available as modulation destinations for the Motion Recorder are:
 VCO1 FM ................ Coarse frequency of oscillator 1
 VCO1 PWM ............. Pulse width of oscillator 1
 VCO1 AM ............... Output level of oscillator 1 (available in the Mixer)
 VCO2 FM ................ Coarse frequency of oscillator 2
 VCO2 PWM ............. Pulse width of oscillator 2
 VCO2 AM ............... Output level of oscillator 2 (available in the Mixer)
 VCO3 FM ................ Coarse frequency Frequency of oscillator 3
 VCO3 PWM ............. Pulse width of oscillator 3
 VCO3 AM ................ Output level of oscillator 3 (available in the Mixer)
 VCO12 FM .............. Coarse frequency of oscillators 1 and 2
 VCO123 FM ............. Coarse frequency of oscillators 1, 2 and 3
 VCO12 PWM ............ Pulse width of oscillators 1 and 2
 VCO123 PWM .......... Pulse width of oscillators 1, 2 and 3
 VCO12 AM ............. Output level of oscillators 1 and 2
 CutOff .................... Filter cut-off frequency
 Emphasis ................ Level of filter resonance
 EG VCF lev.............. Amount of filter envelope
 EG VCA lev. ............ Amount of amplifier envelope
 Glide ...................... Portamento time
 MixMod .................. Balance between oscillator 3 and noise
 Mod.Wheel .............. Amount of internal modulations only (oscillator and filter)
 VCA AM .................. VCA output level
 LFO FM .................. LFO speed
 LFO AM .................. LFO amplitude
 Noise AM ................ Output level of noise generator (available in the Mixer)