Figure 59: Screensaver enabled message
Note:
If the device configuration does not allow the use of a password-free screensaver, this menu
option is not available to you.
Enable (with password):
Enabling the screensaver in password-protected mode prompts you to enter a password before
logging in.
If allowed in the configuration, the user-defined password definition screen is displayed.
The screen displays Enter user password to activate screensaver followed by a user-
input prompt.
The following figure displays the screensaver password screen.
Figure 60: Screensaver password screen
To configure a password:
1. Press the Set context-sensitive soft key.
This context-sensitive soft key appears only if the phone configuration allows the setting of
user-defined passwords. Pressing this key invokes a password definition screen that allows
you to configure a password.
If a user-defined password is not allowed, then the Set context-sensitive soft key is not
visible, and you can use only the primary user login password to enable the password–
protected screensaver.
2. Enter a password. Press the abc/123 context-sensitive soft key to toggle input mode
between numeric or alphabet.
3. Press OK. A Screensaver enabled message appears if the password is valid. An
Invalid password message is displayed if the password is invalid.
Press Back to dismiss the Enable (with password) mode menu.
Advanced features
August 2017 Avaya 1140E IP Deskphone with SIP Software User Guide 234
Comments on this document? infodev@avaya.com
To Next Page
Loading...
