Command Description
DIS MSGI x (options) Disable the monitoring of incoming messages on D-
channel x.
DIS MSGI <dch> debg CH <loop><channel>
Disable the debugging of all monitored incoming
messages from D-channel card.
A maximum of 5
channels are monitored at a time. Only one channel
number can be entered in one command.
DIS MSGI x FEAT CPNW Disable incoming monitoring for the Network CPNW
ISDN messages on D-channel x.
DIS MSGI <dch> debg MSG msg1 msg2 msg3
Disable the debugging of all monitored incoming
messages from D-channel. This command can be
entered more than once. Only 3 message mnemonics
can be given in one command.
DIS MSGI <dch> debg SET
Disable debug SET on all incoming messages from D-
channel. This set-based filtering is enhanced for UIPE
proprietary messages.
DIS MSGO x (options) Disable the monitoring of outgoing messages on D-
channel x
DIS MSGO <dch> debg CH <loop><channel>
Disable the debugging of all monitored outgoing
messages from D-channel card. A maximum of 5
channels are monitored at a time. Only one channel
number can be entered in one command.
DIS MSGO x FEAT CPNW Disable outgoing monitoring for the Network CPNW
ISDN messages on D Channel x.
DIS MSGO <dch> debg MSG msg1 msg2 msg3
Disable the debugging of all monitored outgoing
messages from D-channel. This command can be
entered more than once. Only 3 message mnemonics
can be given in one command.
DIS MSGO <dch> debg SET
Disable debug SET on all outgoing messages from D-
channel. This set-based filtering is enhanced for UIPE
proprietary messages.
DIS SERV x Disable service messages on D-channel x
DLIF DCH x Force download of D channel x (For PRI UIPE
application).
D-channel maintenance
58 ISDN Primary Rate Interface Maintenance November 2011
Comments? infodev@avaya.com
To Next Page
Loading...
