Command Description
ENL AUTO x Enable automatic recovery for DCH x.
ENL DCH x (FDL) Enable DCH x and attempt to establish the link, and
force download to MSDL.
ENL MSGI x (options) Enable the monitoring of incoming messages on D-
channel x.
ENL MSGI <dch> debg CH <loop><channel>
Enable the debugging of all monitored incoming
messages from D-channel card.
A maximum of 5
channels are monitored at a time. Only one channel
number can be entered in one command.
ENL MSGI x FEAT CPNW Enable incoming monitoring for the Network CPNW
ISDN messages on D-channel x.
ENL MSGI <dch> debg MSG msg1 msg2 msg3
Enable the debugging of all monitored incoming
messages from D-channel. This command can be
entered more than once. In one command, only 3
message mnemonics can be given.
ENL MSGI <dch> debg SET
Enable debug SET on all incoming messages from D-
channel. This set-based filtering is enhanced for UIPE
proprietary messages.
ENL MSGO x (options) Enable the monitoring of outgoing messages on D-
channel x.
ENL MSGO <dch> debg CH <loop><channel>
Enable the debugging of all monitored outgoing
messages from D-channel card. A maximum of 5
channels are monitored at a time. Only one channel
number can be entered in one command.
ENL MSGO x FEAT CPNW Enable outgoing monitoring for the Network CPNW
ISDN messages on D-channel x.
ENL MSGO <dch> debg MSG msg1 msg2 msg3
Enable the debugging of all monitored outgoing
messages from D-channel. This command can be
entered more than once. Only 3 message mnemonics
can be given in one command.
ENL MSGO <dch> debg SET
Enable debug SET on all outgoing messages from D-
channel. This set-based filtering is enhanced for UIPE
proprietary messages.
DCH commands (LD 96)
ISDN Primary Rate Interface Maintenance November 2011 59
To Next Page
Loading...
