Command Description
ENL SERV x Enable service messages on D-channel x.
EST DCH x Establish multiple frame operation on D-channel x.
EST ISPC l ch (N) Start the data interface establishment process at the
ISPC slave side an ISPC link (where "N" = the "number
of tries" counter).
FDIS NCAL <DCH#> <conn_ID> Force disconnect the specified call-independent
connection.
PLOG DCH x Print protocol error log on D-channel x.
RLS DCH x Release D-channel x.
RLS ISPC l ch Stop the data interface establishment process.
RST DCH x Reset D-channel x, inhibit signaling.
RST MON Reset or reactivate monitoring on D-channels with
enabled monitors.
SDCH DCH x Switch to the standby D-channel x.
SET MSGI x MON (0)-2 Set monitor output format level for incoming messages
on D-channel x.
SET MSGO x MON (0)-2 Set monitor output format level for outgoing messages
on D-channel x.
SLFT TMDI x Invoke self-test x
STAT DCH (x) Get status of one or all D-channels
STAT ISPC l ch Get status of data interface establishment process at
ISPC slave side ISPC link which has been configured
to convey D-channel signaling.
STAT NCAL <DCH#> List all current call-independent connections on a
given PRI D-channel.
STAT NCAL <DCH#> <conn_ID>
List information pertaining to a specific call-
independent connection.
STAT MON (x) Display the incoming and outgoing monitoring status
of one or all D-channels.
STAT SERV (x) Get the enable/disable status of services messages
for one or all D-channels.
STAT TMDI (x FULL) Get TMDI status x.
D-channel maintenance
60 ISDN Primary Rate Interface Maintenance November 2011
Comments? infodev@avaya.com
To Next Page
Loading...
Need help?
General
