Name Description
Dial Plan Specifies the dial plan used in the phone.
Value format: a sting of 0 to 1023 characters without any
intervening spaces.
The default value is empty.
No Digit Dial Timer Specifies the time in seconds during which the phone waits for
a digit to be dialed after going off-hook and before generating a
warning tone.
The valid value is an integer from 0 to 60. The default value is
20 seconds.
Inter-digit Wait Timer Specifies the time in seconds during which phone waits after a
digit is dialed before sending a SIP INVITE.
The valid value is an integer from 0 to 10. The default value is 5
seconds.
Dial Local Area Code Specifies whether the user must dial the area code of calls
within the same area code regions.
The options are:
• No (default)
• Yes
Local Area Code Indicates the phone local area code which allows the user to
dial local numbers with more flexibility.
The valid value is a sting of 5 digits ranged from 0 to 9. The
default value is empty.
Enhanced Local Dialing Rules
Enable Local Dialing Rules Specifies whether the algorithm defined by parameters in this
section is used during certain dialing procedures.
The options are:
• Disable
• Enable without Contacts (default)
• Enable with Contacts
Country Code Specifies the country code of the phone.
The valid value is an integer from 1 to 999. The default value is
1.
International Access Code Specifies the international access code.
The valid value is up to 4 dialable characters. The default value
is 011.
Value format: digits from 0 to 9, *, #.
Table continues…
Phone configuration
July 2019 Installing and Administering Avaya J100 Series IP Phones 127
Comments on this document? infodev@avaya.com
To Next Page
Loading...
