Avaya J129 - Page 300

Parameter name Default
value
Description
SIG 0 Specifies the type of software to be
used by the phone by controlling
which upgrade file is requested
after a power-up or a reset.
Value operation:
0: Download the upgrade file for the
same signaling protocol that is
supported by the current software
(default)
2: Download J100Supgrade.txt
SIG_PORT_LOW Specifies the minimum port value
for SIP signaling. (1024 -65503).
SIG_PORT_RANGE Specifies the range or number of
SIP signaling ports. This value is
added to SIG_PORT_LOW to
determine the upper limit of the SIP
signaling port range (32-64511).
SIGNALING_ADDR_MODE 4 Specifies the SIP controller IP
address from
SIP_CONTROLLER_LIST_2. This
parameter is used by SIP signaling
on a dual mode phone.
The single IPv4 mode phone
ignores
SIGNALING_ADDR_MODE and
SIP_CONTROLLER_LIST_2 and
selects the SIP controller's IP
addresses from
SIP_CONTROLLER_LIST.
The single IPv6 mode phone
ignores
SIGNALING_ADDR_MODE and
SIP_CONTROLLER_LIST and
selects the SIP controller's IPv6
addresses from
SIP_CONTROLLER_LIST_2.
Value operation:
• 4: IPv4
• 6: IPv6
Table continues…
Customizable parameters
July 2019 Installing and Administering Avaya J100 Series IP Phones 300
Comments on this document? infodev@avaya.com