Parameter name Default
value
Description
SIMULTANEOUS_REGISTRATIONS 3 Specifies the number of Session
Managers with which the phone
simultaneously register.
Valid values are 1, 2 or 3. The
default value is 3.
Note:
This parameter is set to 1 in IP
Office environment.
SIP_CONTROLLER_LIST Null Specifies a list of SIP controller
designators, separated by commas
without any spaces. The list is used
on IPv4-only and dual mode
phones if
SIP_CONTROLLER_LIST_2 is not
provided. Controller designator has
the following format: host[:port]
[;transport=xxx] where
• host is an proxy address in
dotted-decimal or DNS name
format. In third-party call control
setup, only DNS format is
supported.
• [:port] is an optional port
number.
• [;transport=xxx] is an
optional transport type where xxx
can be TLS, TCP, or UDP.
For example,
SIP_CONTROLLER_LIST="10.13
8.251.56:5060;transport=tc
p"
Table continues…
List of configuration parameters
July 2019 Installing and Administering Avaya J100 Series IP Phones 301
Comments on this document? infodev@avaya.com
To Next Page
Loading...
