Avaya J129 - Page 302

Parameter name Default
value
Description
SIP_CONTROLLER_LIST_2 Null This parameter replaces
SIP_CONTROLLER_LIST for dual
mode phones. It contains the list of
SIP Proxy or Registrar servers
separated by comma when the SIP
device is configured for the dual-
stack operation.
SIP_CONTROLLER_LIST_2 is
used on IPv6-only phones to
provide the list of SIPv6 servers.
SIPv4 servers are ignored in IPv6-
only mode.
Valid values are 0 to 255 characters
in the dotted decimal or colon-hex
format.
The SIP Proxy list has the following
format: host[:port]
[;transport=xxx] where
• host is IP addresses in dotted-
decimal format or hex format.
• [:port] is the port number. The
default values are 5060 for TCP
and 5061 for TLS.
• [;transport=xxx] is the
transport type and xxx is either
TLS or TCP. The default value is
TLS.
For example,
SIP_CONTROLLER_LIST_2="10.
16.26.88:5060;transport=tc
p"
SIPDOMAIN
Null Specifies the domain name to be
used during SIP registration.
The value can contain 0 to 255
characters. The default value is
null.
SIPPORT 5060 Specifies the port the phone opens
to receive SIP signaling messages.
Valid values are 1024 through
65535. The default value is 5060.
Table continues…
Customizable parameters
July 2019 Installing and Administering Avaya J100 Series IP Phones 302
Comments on this document? infodev@avaya.com