Avaya J129 - Page 304

Parameter name Default
value
Description
SLMPERF 0 Specifies whether the SLA Monitor
agent is enabled for phone
performance monitoring.
Value operation:
• 0: Disabled
• 1: Enabled
SLMPORT 50011 Specifies the UDP port that will be
opened by the SLA Monitor agent
to receive discovery and test
request messages.
Valid values are 6000 through
65535. The default value is 50011.
Note:
If default port is not used, both
the SLA Mon agent and the
server must be configured with
the same port. This parameter
impacts the phone's SLA Mon
agent configuration. A
corresponding configuration
must also be made on the SLA
Mon server agentcom-
slamon.conf file.
Table continues…
Customizable parameters
July 2019 Installing and Administering Avaya J100 Series IP Phones 304
Comments on this document? infodev@avaya.com