Avaya J129 - Page 305

Parameter name Default
value
Description
SLMSRVR Specifies the IP address and the
port number of the SLA Mon server
in the aaa.bbb.ccc.ddd:n format.
Set the IP address of the SLA Mon
server in the aaa.bbb.ccc.ddd
format to restrict the registration of
agents only to that server.
Specifying a port number is
optional. If you do not specify a port
number, the system takes 50011 as
the default port. If the value of the
port number is 0, than any port
number is acceptable.
The IP address must be in the
dotted decimal format, optionally
followed by a colon and an integer
port number from 0 to 65535.
To use a non-default port, set the
value in the aaa.bbb.ccc.ddd:n
format, where aaa.bbb.ccc.ddd is
the IP addressof the SLA Mon
server.
Note:
If default port is not used, both
the SLA Mon agent and server
must be configured with the
same port. SLMSRVR impacts
the phone's SLA Mon agent
configuration. A corresponding
configuration must also be
made on the SLA Mon server
agentcom-slamon.conf file
SLMSTAT 0 Specifies if the SLA Monitor agent
is enabled or not.
Value operation:
• 0: Disabled
• 1: Enabled
Table continues…
List of configuration parameters
July 2019 Installing and Administering Avaya J100 Series IP Phones 305
Comments on this document? infodev@avaya.com