Avaya J129 - Page 316

Parameter name Default
value
Description
WAIT_FOR_CALL_OPERATION_RESPONSE 3 Specifies the time in seconds
before providing the user a
notification that there is a call
operation in progress. This
parameter is applicable to all server
environments.
Example: User goes off-hook, the
phone sends an invite. If there is no
response from the proxy for three
(default value) seconds, the phone
will display the notification.
Valid values range from 0 to 4.
• 0: the notification is disabled
• 1 – 4: the number of seconds
before the popup display
WAIT_FOR_INVITE_RESPONSE_TIMEOUT 60 Specifies the maximum number of
seconds that the phone waits for
another response after receiving a
SIP 100 Trying response.
Valid values are 30 through 180.
WAIT_FOR_REGISTRATION_TIMER 32 Specifies the number of seconds
that the phone waits for a response
to a REGISTER request.
If no response message is received
within this time, registration will be
retried based on the value of
RECOVERYREGISTERWAIT.
Valid values are 4 through 3600.
WAIT_FOR_UNREGISTRATION_TIMER 32 Specifies the number of seconds
the phone waits before assuming
that an un-registration request is
complete.
Un-registration includes termination
of registration and all active dialogs.
Valid values are 4 through 3600.
Table continues…
Customizable parameters
July 2019 Installing and Administering Avaya J100 Series IP Phones 316
Comments on this document? infodev@avaya.com