30
Double-click the mouse left button any area within that specific window to enter the Remote mode (or
move the Host cursor to the top-right corner of the targeted window and then click the Enter remote
mode icon).
To switch back to Host mode, use keyboard “Pause/Break” hotkey, or double-click the mouse scroll
button. The Host cursor will reappear.
To close a specific window, move the Host cursor on the window and double-click the mouse right
button to close it.
To add a window, move the Host cursor to the blank area, click and hold the mouse left button to draw
a rectangle outline (the minimum size of the rectangle is one-sixth of width/height of the output
resolution), then release the mouse left button, the newly added window will appear on the screen.
Please keep in mind the newly add window CANNOT overlay with the other three windows during creation.
To route an input source to display on the monitors, using keyboard “Ctrl – 1 – 1” hotkey will load input
source 1 to display on the monitor in fullscreen mode; “Ctrl – 1 – 4” hotkey will load input source 4 to
display on the monitor in fullscreen mode.
Move the Host cursor to the top-right position, the pop-up selections will appear upon
moving the Host cursor to the top-right of each window.
Figure 3.3.1.1 Pop-up Selections of Quad-view Window
If there is a duplicated quad display on HDMI OUT 2 to HDMI OUT 4, the fullscreen icon in pop-up selections
for each window of HDMI OUT 1 will be greyed out of the HDMI OUT 1.
Or, when in fullscreen window upon moving the Host cursor to the window’s top-right position, the
pop-up selections will appear.
Figure 3.3.1.2 Pop-up Selections of Fullscreen Window
To Next Page
Loading...