7-16
*1: The meaning of auxiliary setting 1 for special segment is shown below.
–2: Two segments before the final segment 1: First segment
–1: One segment before the final segment 2: Second segment
0: Final segment
*2: When auxiliary setting 1 of RAMP-E time monitoring is set to 0.0 sec, event output is off.
*3: Auxiliary setting 1 and auxiliary setting 2 of segment time and program time that determine display
unit and range of segment are set by setup data C62 settings as follows.
When C62 is set to 0: 0 hours 00 min to 500 hours 00 min
When C62 is set to 1: 0 min 00 sec to 500 min 00 sec
When C62 is set to 2: 0.0 sec to 3000.0 sec
Event type 91 93 9492
Meaning
Message
Segment number
BCD code
SEG-BCD
RAMP-E time monitoring
RAMP-E TIME OUT
Segment time
SEG TIME
Special segment
SEG SEQUENCE
Range of auxiliary
setting 1
Message
Number of output points
1 to 8
channels
Operating point
0.0 to 3000.0sec
*
2
time out
On Time
0:00 to 500:00
*3
on-time
Segment specification
-2 to +2
*
1
segment
Range of auxiliary
setting 2
Message
Unused Unused Off Time
0:00 to 500:00
*3
off-time
Unused
Setting category
Operation category
Instrument type
Code type
Instrument type
Time type
Instrument type
Time type
Instrument type
Mode type
Event type 95 97 9896
Meaning
Message
Program time
PROG TIME
PV1-PV2 differential lower limit
during CH switching
CHG. P-CH-DEV-L
PV1-PV2 differential upper limit
CH-DEV-H
PV1-PV2 differential upper limit
during CH switching
CHG. P-CH-DEV-H
Range of auxiliary
setting 1
Message
On Time
0;00 to 500;00
*
3
on-time
Unused Hysteresis
0 to 1000 SPU
hysteresis
Unused
Range of auxiliary
setting 2
Message
Off Time
0:00 to 500:00
*
3
off-time
Operating point
-19999 to +20000 SPU
set point
Operating point
-19999 to +20000 SPU
set point
Operating point
-19999 to +20000 SPU
set point
Setting category
Operation category
Instrument type
Time type
Instrument type
PV type
Instrument type
PV type
Instrument type
PV type
To Next Page
Loading...
