Basler GigE SERIES - 7.11 Acquisition Timing Chart

Image Acquisition Control AW00089317000
138 Basler ace GigE
Selecting the Flash Window Signal as the Source Signal for the Output Line
The flash window output signal can be selected to act as the source signal for camera output line 1.
1. Use the Line Selector to select output line 1.
2. Set the value of the Line Source Parameter to the flash window signal.
You can set the Line Selector and the Line Source parameter value from within your application
software by using the Basler pylon API. The following code snippet illustrates using the API to set
the selector and the parameter value:
Camera.LineSelector.SetValue( LineSelector_Out1 );
Camera.LineSource.SetValue( LineSource_FlashWindow );
You can also use the Basler pylon Viewer application to easily set the parameters.
For more information about
 the pylon API and the pylon Viewer, see Section 3 on page 45.
 changing which camera output signal is selected as the source signal for the output line, see
Section 6.2.1 on page 74.
 the electrical characteristics of the camera’s output line, see Section 5.8 on page 67.
To select a source signal for the output line: