AW00089317000 Physical Interface
Basler ace GigE 67
5.8 Output Line Description
5.8.1 Voltage Requirements
The following voltage requirements apply to the I/O output line (pin 4 of the 6-pin connector):
5.8.2 Characteristics
The camera is equipped with one physical output line designated as Output Line 1. The output line
is accessed via the 6-pin connector on the back of the camera.
As shown in Figure 42, the output line is opto-isolated. See the previous section for the
recommended operating voltages. The maximum current allowed through the output circuit is
50 mA.
A low output signal from the camera results in a non-conducting Q1 transistor in the output circuit.
NOTICE
Voltage outside of the specified range can cause damage.
Note that the recommended voltage range for the output line
differs from the recommended voltage ranges for camera power (see Section 5.5 on
page 61) and for the input line (see Section 5.7.1 on page 63). You must supply power within
the specific voltage range.
of Basler ace GigE cameras can differ from the recommended voltage ranges for the I/O
output lines of other Basler cameras. You must supply power within the specified voltage
range.
Voltage Significance
< +3.3 VDC The I/O output may operate erratically.
+3.3 to +24 VDC Recommended I/O output voltage.
Table 12: Voltage Requirements for the I/O Output
To Next Page
Loading...
Need help?
General
