Basler GigE SERIES User Manual

Physical Interface AW00089317000
66 Basler ace GigE
5.7.4 Selecting the Input Line as the Source Signal for
a Camera Function
You can select input line 1 to act as the source signal for the following camera functions:
 the acquisition start trigger
 the frame start trigger
 the frame counter reset
 the trigger input counter reset
Note that when the input line has been selected as the source signal for a camera function, you
must apply an electrical signal to the input line that is appropriately timed for the function.
For more information about selecting input line 1 as the source signal for a camera function, see
Section 6.1 on page 71.

Basler GigE SERIES Specifications

General

Interface	GigE
Lens Mount	C-Mount, CS-Mount
Sensor	CMOS
Mount	C-mount, CS-mount
Power Supply	Power over Ethernet (PoE)
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	Varies by model