AW00089317000 Physical Interface
Basler ace GigE 63
5.7 Input Line Description
5.7.1 Voltage Requirements
:
Voltage Levels When the Standard Power and I/O Cable is Used
The following voltage requirements apply to the camera’s I/O input line (pin 2 of the 6-pin connector)
when a standard power and I/O cable is used:
NOTICE
Voltage outside of the specified range can cause damage.
The recommended voltage range
for the input line differs from the recommended voltage ranges for camera power (see
Section 5.5 on page 61) and for the output line (see Section 5.8.1 on page 67).
for the I/O input line of Basler ace GigE cameras can differ from the recommended voltage
ranges for the I/O input lines of other Basler cameras.
You must supply power within the specified voltage range.
Different voltage levels apply, depending on whether the standard power and
I/O cable or a PLC power and I/O cable is used (see below).
Significance If Standard Power
and I/O Cable is used
If
PLC Power and I/O Cable is used
Recommended
I/O input voltage.
+0 to +24 VDC +0 to +24 VDC
Voltage indicates
a logical 0.
+0 to +1.4 VDC +0 to +8.4 VDC
Region where the transition
threshold occurs; the logical state is
not defined in this region.
> +1.4 to +2.2 VDC > +8.4 to +10.4 VDC
The voltage indicates a logical 1. > +2.2 VDC > +10.4 VDC
Table 11: Voltage Requirements (I/O Input Line)
To Next Page
Loading...
