Physical Interface AW00089317000
60 Basler ace GigE
5.4.3 PLC Power and I/O Cable
As with the standard power and I/O cable described in the previous section, the PLC power and
I/O cable is a single cable that both connects power to the camera and connects to the camera’s
I/O lines. The PLC power and I/O cable adjusts the voltage levels of PLC devices to the voltage
levels required by the camera and it protects the camera against negative voltage and reverse
polarity.
Close proximity to strong magnetic fields should be avoided.
Basler offers a PLC power and I/O cable that is terminated with a 6-pin Hirose plug (HR10A-7P-6S)
on the end that connects to the camera. The other end is unterminated. Contact your Basler sales
representative to order the cable.
For information about the applicable voltage levels, see Section 5.7.1 on page 63.
We recommend using a PLC power and I/O cable, if the camera is connected to
a PLC device.
If power for the I/O input is supplied at 24 VDC, you can use a PLC power and
I/O cable when the camera is not connected to a PLC device.
We recommend that you supply power to the camera either via the camera’s RJ-
45 jack or via the camera’s 6-pin connector.
To Next Page
Loading...
