Basler GigE SERIES User Manual

Physical Interface AW00089317000
62 Basler ace GigE
For more information about the 6-pin connector and the power and I/O cables see Section 5.2 on
page 56, Section 5.3 on page 57, and Section 5.4 on page 58.
5.6 Ethernet GigE Device Information
The camera uses a standard Ethernet GigE transceiver. The transceiver is fully 100/1000 Base-T
802.3 compliant.
NOTICE
An incorrect plug can damage the 6-pin connector.
The plug on the cable that you attach to the camera’s 6-pin connector must have 6 female pins.
Using a plug designed for a smaller or a larger number of pins can damage the connector.

Basler GigE SERIES Specifications

General

Interface	GigE
Lens Mount	C-Mount, CS-Mount
Sensor	CMOS
Mount	C-mount, CS-mount
Power Supply	Power over Ethernet (PoE)
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	Varies by model