Basler GigE SERIES User Manual

AW00089317000 Standard Features
Basler ace GigE 309
10.19.4 Selecting the Startup Set
You can select the default configuration set (i.e., whichever was selected as the default
configuration set, either the Standard Factory Setup, the High Gain Factory Setup, or the Auto
Functions Factory Setup) or one of the user configuration sets stored in the camera’s non-volatile
memory to be the "startup set". The configuration set that you designate as the startup set will be
loaded into the active set whenever the camera starts up at power on or after a reset.
1. Set the User Set Default Selector to User Set 1, User Set 2, User Set 3 or Default.
You can set the User Set Default Selector from within your application software by using the pylon
API. The following code snippet illustrates using the API to set the selector:
Camera.UserSetDefaultSelector.SetValue(
UserSetDefaultSelector_Default );
For more information about the Basler pylon API and the pylon Viewer, see Section 3 on page 45.
To select the startup set:

Basler GigE SERIES Specifications

General

Interface	GigE
Lens Mount	C-Mount, CS-Mount
Sensor	CMOS
Mount	C-mount, CS-mount
Power Supply	Power over Ethernet (PoE)
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	Varies by model