Basler GigE SERIES User Manual

Standard Features AW00089317000
292 Basler ace GigE
10.13.9 Using an Auto Function
1. Select an Auto Function AOI.
2. Assign the auto function you want to use to the selected Auto Function AOI.
3. Unassign the auto function you want to use from the other Auto Function AOI.
4. Set the position and size of the Auto Function AOI.
5. If necessary, set the lower and upper limits for the auto functions’s parameter value.
6. If necessary, set the target value.
7. Set the GrayValueAdjustmentDampingAbs parameter.
8. If necessary, set the auto function profile to define priorities between auto functions.
9. Enable the auto function by setting it to "once" or "continuous".
For more information about the individual settings, see the previous sections that describe the
individual auto functions.
To use an auto function:

Basler GigE SERIES Specifications

General

Interface	GigE
Lens Mount	C-Mount, CS-Mount
Sensor	CMOS
Mount	C-mount, CS-mount
Power Supply	Power over Ethernet (PoE)
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	Varies by model