Basler GigE SERIES User Manual

AW00089317000 Physical Interface
Basler ace GigE 61
5.5 Camera Power
Via PoE
(Power over Ethernet)
Power
via power and I/O cable
 Via Ethernet cable plugged into camera’s RJ-45
connector.
 Power must adhere to requirements specified in
IEEE 802.3af.
 From a power supply via a power and I/O cable
(either a standard cable or a PLC cable) plugged
into the camera’s
6-pin connector.
 Nominal operating voltage:
12 VDC (± 10%) with less than one percent ripple
 Power consumption -> see specification tables in Section 1 of this manual.
 Close proximity to strong magnetic fields should be avoided.
We recommend that you supply power to the camera either via the camera’s RJ-
45 jack or via the camera’s 6-pin connector.
NOTICE
Voltage outside of the specified range can cause damage.
If the voltage of the power to the camera is greater than +13.2 VDC, damage to the camera can
result. If the voltage is less than +10.8 VDC, the camera may operate erratically.
NOTICE
Voltage outside of the specified range can cause damage.
Note that the recommended voltage range for camera power
 (see above) differs from the recommended voltage ranges for the input and output lines (see
Section 5.7.1 on page 63 and Section 5.8.1 on page 67).
 for Basler ace GigE cameras can differ from the recommended voltage range for camera
power for other Basler cameras.

Basler GigE SERIES Specifications

General

Interface	GigE
Lens Mount	C-Mount, CS-Mount
Sensor	CMOS
Mount	C-mount, CS-mount
Power Supply	Power over Ethernet (PoE)
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	Varies by model