Standard Features AW00089317000
246 Basler ace GigE
When the next frame start trigger is received, the camera checks the active set and uses it for
the image acquisition. The parameter values of sequence set 0 are used.
Another sequence set cycle has started
When the next frame start trigger is received, the camera checks the active set and uses it for
the image acquisition. The parameter values of sequence set 0 are used.
While frame exposure and readout are in progress, the sequencer feature is disabled. The
complete frame is transmitted and the cycling through sequence sets is terminated. The
sequencer parameter values in the active set return to the values that existed before the
sequencer feature was enabled.
Make sure not to send a frame start trigger while the parameter values of a
sequence set are loaded into the active set. During this period, the camera will
not wait for a frame start trigger and any frame start trigger will be ignored.
Make sure to only send a frame start trigger when the camera is in "waiting for
frame start trigger" status.
For information about possibilities of getting informed about the "waiting for
frame start trigger" status, see the Acquisiton Monitoring Tools section.
To Next Page
Loading...
Need help?
General
