AW00089317000 Network Related Camera Parameters and Managing Bandwidth
Basler ace GigE 351
You can lower the data output rate on a camera by using the Inter-packet Delay parameter. This
parameter adds a delay between the transmission of each packet from the camera and thus slows
the data transmission rate of the camera. The higher the inter-packet delay parameter is set, the
greater the delay between the transmission of each packet will be and the lower the data
transmission rate will be. After you have adjusted the Inter-packet Delay parameter on each
camera, you can check the sum of the Bandwidth Assigned parameter values and see, if the sum
is now less than 125 MByte/s.
To Next Page
Loading...
