2 – Installation
39
Daylight Saving Time Window:
Daylight Saving Time checkbox
The Daylight Saving Time field is represented by a day/night icon with an arrow between the
two. Select whether the system clock is automatically set forward one hour for Daylight Saving
Time (checked) or is set at Standard Time (unchecked). The default value is Standard Time
(unchecked).
Set Range button
To set the date range during which Daylight Saving Time is active, select Set Range. In the
Start DST window, tap the
▲ or ▼ button in the Month, Day, and Hour value to set for the
beginning of Daylight Saving Time. In the End DST window, tap the
▲ or ▼ button in the
Month, Day, and Hour value to set for the end of Daylight Saving Time. The Start and End
dates/times are shown to the right of the icon.
When the clock reaches the From date/time, the time automatically advances one hour. When
the clock reaches the To date/time, the time automatically decreases one hour.
Timezone GMT Offset Window:
H(ou)rs
Min(utes)
The Timezone Offset field is represented by a map icon. To change the time zone offset, tap
the
▲ or ▼ button to increase or decrease the value in the Hrs (Hours) or Min(utes) field. This
value is your time zone difference from GMT (Greenwich Mean Time).
Select negative integers if you are west of the Prime Meridian and east of the International
Date Line. Select positive integers if you are east of the Prime Meridian and west of the
International Date Line. Hour values can range from –14 to 14; minutes values can be from 0
to 59.
The default value is –5 hours 0 minutes (USA Eastern Time Zone).
Configuration – Time Buttons:
Undo button
Select to clear changes and return to saved values. Only active if field values are changed and
are not saved.
Select to save changes. When the Enter Password window appears, tap in the blank password
field to display the onscreen keyboard and enter the Supervisor password. Then select
ENTER, followed OK.
Save button
To Next Page
Loading...
