2 – Installation
37
LIS Communications Buttons:
Undo button
Select to clear changes and return to saved values. Only active if field values are changed and are not
saved.
Save button
Select to save changes. When the Enter Password window appears, tap in the blank password
to display the onscreen keyboard and enter the Supervisor password. Select ENTER, followed
by OK.
This button appears only if Log Comms is enabled.
Select to print all the LIS messages in the Event Log. The messages include the time stamp
when the message was generated.
2.4.5 Time Configuration
Time and date configuration settings can only be changed in a standalone configuration. Time and
date may not be changed in a BD EpiCenter™ configuration.
To modify default values, refer to the field requirements listed below. When changes are complete,
selec
t Save. See Figure 2-8.
Date/Time Window:
Date
The current date is shown next to the Calendar icon. To change the date, select Set at the right
of the Date/Time window.
The current time field is shown next to the Clock icon. To change the time, select Set at the
right of the Date/Time window.
Set Button
Select Set to display the Set Date and Time window (Figure 2-9). To set the date, tap the ▲ or
▼ button in the Month, Day, or Year field. To set the time, tap the ▲ or ▼ button in the Hour
or Minute field. For USA locations, select a.m. or p.m. by tapping the Drop Down Arrow next
to the a.m./p.m. field to select either value. Select OK when complete to set the new Date/
Time. Select Cancel to exit the window without changing the date or time.
Print button
Time
To Next Page
Loading...
