BD BACTEC FX40™ Instrument User’s Manual
86
Wrong button
Appears only if the vial sequence number was entered manually and Batch Removal is
dis
abled. Select to inform the system that the displayed vial sequence number is incorrect.
Message WE06 then appears (see Section 7).
Exit button
Select to exit the display and return to the Status display.
5.3.3 ID(entify) Anonymous Display
The ID Anonymous display enables you to identify ongoing anonymous and positive anonymous vials.
You are informed of anonymous vials by the following:
• Station indicators: FLASHING YELLOW – Ongoing Anonymous
FLASHING YELLOW / RED (alternating) – Positive Anonymous
• Identify Anonymous Vials button active on Status display
• Anonymous counter on activity displays
In order to complete the identification process, you must
place the vial into an available station or
select Save if the vial is to be kept out of the instrument (e.g., a Positive Anonymous vial you have just
identified).
Anonymous vials do not go out of protocol
(Negative) until they are identified.
You cannot identify anonymous vials in an in
strument that is in degraded mode.
See Figure 5-4 for a sample ID Anonymous display.
To access ID Anonymous:
• Open a drawer and remove a FLASHING YELLOW or
FLASHING YELLOW / FLASHING RED
vial, or
• Open a drawer and select Ide
ntify Anonymous on the Status display
ID Anonymous Fields:
Accession
Scan or type in the accession number [up to 20 alphanumeric characters, excluding the
follow
ing:
* ? [ ] ! # |
Accession number cannot be 12 digits long AND begin with the numbers “44.”
Sequence
Scan or type in the vial barcode sequence numbe
r located on the vial label. Sequence number
is a 12-digit number beginning with “44.”
Medium
If the sequence number is scanned or typed in, th
e medium type is automatically entered in
this field. You have to manually select a medium from the drop-down box for medium type “99”
(replacement barcode).
To Next Page
Loading...
