45
Navigation mode
Deleting a stopover
If you have entered a stopover, you can
delete it before reaching it.
X In the Options menu, select the 6WRS
RYHU
entry again.
X Select <HV (delete stopover) or 1R
(retain stopover).
If
<HV is selected, the stopover is deleted
and route guidance to the main destina-
tion started automatically.
Blocking a route
You can use this function to block a sec-
tion of the route still to be travelled when
the next junction is reached. If possible,
the Traffic Pro will then calculate a
diversion route. This may be useful if a
traffic jam or road block lies immedi-
ately ahead.
X In the Options menu, select the %ORFN
entry.
X Turn the rotary control/push button
to select the required distance to be
blocked.
X Confirm your selection by pressing
the rotary control/push button .
The route is recalculated.
Note:
Once the stopover has been reached, the
following display appears.
Route guidance to the main destination
is started automatically.
Note:
If no operator inputs are made, the
menu will automatically disappear after
a few seconds and the stopover will be
retained.
2073
To Next Page
Loading...
