Becker Traffic Pro 7949 - Extended PTT; Repeating a Voice Announcement; System Settings

98
Settings
Extended PTT
If the function is active, voice mode can
be activated automatically by pressing
, , or and you
can input a voice command directly.
X Select 377H[WHQGHG in the voice mode
settings.
X Turn the rotary control/push button
to switch the function on ( ) or off
().
Repeating a voice announcement
If the function has been switched on and
route guidance is active, the last naviga-
tion announcement can be repeated or an
updated navigation announcement out-
put by pressing .
X Select 5HSHDWYRLFHDQQRXQFHPHQW in the
voice mode settings.
X Turn the rotary control/push button
to switch the function on ( ) or off
().
System settings
You can configure various basic settings
on your Traffic Pro to meet your require-
ments in the system settings.
The following possible settings are
available:
For
$XGLR:
• Setting for speed-dependent increase
in volume with
6SHHGGHSHQGHQWYROXPH
• Setting for acoustic signal volume
with
9ROXPHRIZDUQLQJWRQHV
• You can use 'LVSOD\ YROXPH to select
whether a change in volume should be
displayed in graphics format.
• Setting for the volume level of digital
to analogue audio sources with
'LJLWDO
OHYHO
• Setting for or switching on/off of sub-
woofer output
6XEZRRIHU.
Note:
The abbreviation PTT stands for “Push
To Talk”.
7012
7013