Becker Traffic Pro 7949 - Traffic Announcements; Announcing the Time of Arrival

52
Navigation mode
• (7$VHWWLQJ
You can configure the calculation of
the ETA. ETA stands for Estimated
Time of Arrival.
•
8QLWRIPHDVXUH
You can convert the calculation of the
distances from metric (display in metres
and kilometres) to imperial (display in
yards and miles) system and vice versa.
Traffic announcements
You can specify whether or not traffic
announcements should be read out auto-
matically by the Traffic Pro and, if so,
which ones.
X In the Settings menu, select the 7UDIILF
PHVVDJHV
entry.
X Confirm your selection by pressing
the rotary control/push button .
X You may now select $QQRXQFH PHV
VDJHV
, 2QURXWHRQO\ or :DUQLQJVRQO\.
•
$QQRXQFHPHVVDJHV
If this function is active, all traffic
announcements are made automati-
cally on receipt.
•
2QURXWHRQO\
If you activate this function ( ),
only the traffic announcements rele-
vant to the route are made.
• :DUQLQJVRQO\
Activate this function ( ) to have only
warnings announced.
X Turn the rotary control/push button
to switch the required function on ( )
or off ( ).
Announcing the time of arrival
You can specify whether the calculated
time of arrival should be announced
automatically once the route has been
calculated/recalculated.
X In the Settings menu, select the
$QQRXQFHDUULYDOWLPH entry.
X Press the rotary control/push button
to switch the announcement of the time
of arrival on ( ) or off ( ).
2086
Note:
This setting must be active ( ) in order
to be able to activate the two other
settings.
2087
2088