Becker Traffic Pro 7949 - Voice Entries; Voice Output

97
Settings
Voice entries
You can use this function to read out and
delete all voice entries already stored for
the radio and address book functions.
X Select 9RLFH HQWULHV in the voice mode
settings.
Reading out:
X Select 5HDGRXWUDGLRor 5HDGRXWDGG
ERRN
.
The selected voice entries are read out.
Deleting:
X Select 'HOHWH UDGLR or 'HOHWH DGGUHVV
ERRN
.
X When the next prompt appears, select
<HV to delete the entry or 1R not to
delete.
Entries will be deleted or retained on the
basis of the selection.
Voice output
You can configure voice outputs for the
Traffic Pro here.
X Select 9RLFH RXWSXW in the voice mode
settings.
X You may now select the 6LJQDOSULRUWR
YRLFHLQSXW
, &RQILUPYRLFHLQSXW and 'HWDLOHG
YRLFHRXWSXW
functions.
•
6LJQDOSULRUWRYRLFHLQSXW
Once the function has been activated,
in addition to being highlighted on the
Traffic Pro, a beep tone sounds to
indicate that the unit is ready for a
voice command.
•
&RQILUPYRLFHLQSXW
If the function is active, the voice
command is repeated by the Traffic
Pro for confirmation. However, please
note that the voice command repeated
may not tally exactly with the voice
command you entered. It may be the
case, for example, that you say “end”
and the Traffic Pro repeats “cancel”.
In voice mode, these two commands
have the same meaning.
•
'HWDLOHGYRLFHRXWSXW
If the function is active, in some places
you will receive detailed instructions
(e.g. for entering a destination in voice
mode).
X Turn the rotary control/push button
to switch the required function on ( )
or off ( ).
Note:
The number of voice entries already
assigned appears on the right-hand side
of the display. If, as in the example
display, no voice entries have yet been
created, it will not be possible to assign
the individual entries.
7010
7011