02 36 nn 00 --- NNNNNN Set Serial number detectors
02 37 nn 00 --- NN Set Ticks (a) on/off (1/0)
02 37 nn 01 --- NN Set Ticks b on/off (1/0)
Nuclide parameters
Detector type: nn = 1..20, Nuclide index: jj = 1..71 for nuclides, 1..20 for measurement modes
02 39 nn jj --- NNNNNN Nuclide/Measurement type Name
NN Nuclide/Measurement type activate (0/1)
NN Nu/Ma Radiation type
(0=a, 1=b, 2=g, 3=n)
NNNNNN Nuclide/Measurement type Unit (Text)
float Nuclide/Measurement type threshold
float Nuclide/Measurement type integral threshold
NNNNNN Nuclide/Measurement type integral unit (Text)
NN Nuclide/Measurement type Time base
(0=s, 1=min, 2=h)
float Nuclide/Measurement type k-factor (din)
float Nuclide/Measurement type k-factor iso
02 40 nn 00 --- NN Number of nuclides of detector
(read only)
02 41 nn 00 --- NN Number of fixed nuclides of detector
(read only)
02 42 nn 00 --- NN Number of nuclides of detector
(read only)
Remarks:
For data format number, any entry is permitted (e.g.: 123, 3.45).
For integer, only integers without commas may be entered.
Numerical input in exponential presentation possible, for example, 1.3E06.
Error messages:
Instead of the data, error messages from the LB 134 may be displayed (message instead of data):
a) - 1
Data have no meaning, for example: b values in only a channel for a/b detector.
b) Status: Character no. 2 Bit 4 set.
Data memory has been overwritten via the read mark
If over a longer time the FIFO is not read, but the storage continues cyclically, the read mark of the
last element read is eventually passt by the write pointer, so that data that are still unread will be
overwritten from here on. If thereafter the oldest FIFO element is read, in the status character no. 2
bit 4 is set and the reading mark is placed directly in front of the write pointer.
c) --FIFO BOTTOM--
Data memory read mark reset to the beginning
To Next Page
Loading...
