Binder M 56 - Page 3

M (E3.1) 1/2023 page 3/136
7. START UP ............................................................................................................ 36
7.1 Turning on the chamber .................................................................................................................... 36
7.2 Controller settings upon start up ....................................................................................................... 36
7.3 Loading.............................................................................................................................................. 37
8. SET-POINT ENTRY IN “FIXED VALUE” OPERATING MODE ........................... 38
8.1 Set-point entry for temperature and fan speed through the “Setpoints” menu ................................. 38
8.2 Adjusting the air flap position through the “Setpoints” menu ............................................................ 39
8.3 Direct setpoint entry via Normal display ............................................................................................ 40
8.4 Special controller functions via operation lines ................................................................................. 41
9. TIMER PROGRAM: STOPWATCH FUNCTION .................................................. 42
9.1 Starting a timer program ................................................................................................................... 42
9.1.1 Performance during program delay time ................................................................................. 42
9.2 Stopping a running timer program .................................................................................................... 43
9.2.1 Pausing a running timer program ............................................................................................ 43
9.2.2 Cancelling a running timer program ........................................................................................ 43
9.3 Performance after the end of the program ........................................................................................ 43
10. TIME PROGRAMS ............................................................................................... 44
10.1 Starting an existing time program ..................................................................................................... 44
10.1.1 Performance during program delay time ................................................................................. 45
10.2 Stopping a running time program ...................................................................................................... 45
10.2.1 Pausing a running time program ............................................................................................. 45
10.2.2 Cancelling a running time program ......................................................................................... 45
10.3 Performance after the end of the program ........................................................................................ 45
10.4 Creating a new time program ............................................................................................................ 46
10.5 Program editor: program management ............................................................................................. 46
10.5.1 Deleting a time program .......................................................................................................... 47
10.6 Section editor: section management ................................................................................................. 48
10.6.1 Add a new program section ..................................................................................................... 49
10.6.2 Copy and insert or replace a program section ........................................................................ 49
10.6.3 Deleting a program section ..................................................................................................... 50
10.7 Value entry for a program section ..................................................................................................... 51
10.7.1 Section duration ....................................................................................................................... 51
10.7.2 Set-point ramp and set-point step ........................................................................................... 52
10.7.3 Special controller functions via operation lines ....................................................................... 53
10.7.4 Setpoint entry for temperature and fan speed, setting the air flap position ............................. 54
10.7.5 Tolerance ranges ..................................................................................................................... 55
10.7.6 Repeating one or several sections within a time program ...................................................... 55
10.7.7 Saving the time program ......................................................................................................... 56
11. WEEK PROGRAMS ............................................................................................. 57
11.1 Starting an existing week program .................................................................................................... 57
11.2 Cancelling a running week program ................................................................................................. 57
11.3 Creating a new week program .......................................................................................................... 58
11.4 Program editor: program management ............................................................................................. 59
11.4.1 Deleting a week program......................................................................................................... 60
11.5 Section editor: section management ................................................................................................. 61
11.5.1 Add a new program section ..................................................................................................... 62
11.5.2 Copy and insert or replace a program section ........................................................................ 62
11.5.3 Deleting a program section ..................................................................................................... 63
11.6 Value entry for a program section ..................................................................................................... 63
11.6.1 Set-point ramp and set-point step modes ............................................................................... 63
11.6.2 Weekday .................................................................................................................................. 64
11.6.3 Start time ................................................................................................................................. 64
11.6.4 Setpoint entry for temperature and fan speed, setting the air flap position ............................. 65
11.6.5 Special controller functions via operation lines ....................................................................... 65