Binder M 56 - Stopping a Running Timer Program; Pausing a Running Timer Program; Cancelling a Running Timer Program; Performance after the End of the Program

M (E3.1) 1/2023 page 43/136
9.2 Stopping a running timer program
9.2.1 Pausing a running timer program
Press the Program pause icon to interrupt the program.
The program is paused. The program runtime stops running down, the time display flashes.
There are the following options:
Press the Program start icon to continue the program
Press the Cancelling icon to cancel the program
9.2.2 Cancelling a running timer program
Press the Program cancelling icon to cancel the program.
A confirmation prompt is displayed. Press the Confirm icon to confirm that the program shall really be
cancelled.
After confirming the message, the controller changes to Fixed value operation mode. The setpoints of Fixed
value operation mode will then equilibrate.
9.3 Performance after the end of the program
After the end of the program the message “Device
changes to fixed value operation mode” appears on
the screen.
Press the Confirm icon.
After confirming the message, the controller changes to Fixed value operation mode. The setpoints of Fixed
value operation mode will then equilibrate.