Channel Status
The channel status at the top of each camera controller displays the camera label, On Air
indicator and lock button. Press the lock button to lock all the controls for a specific camera.
When on air, the channel status illuminates red and displays the On Air alert.
Camera Settings
The camera settings button near the bottom left of
the master wheel lets you adjust detail settings for
each camera’s picture signal.
Each camera controller displays the channel status
so you know which camera is on air. Usethecolor
wheels to adjust each YRGB channel’s lift, gamma
and gain settings.
Detail
Use this setting to sharpen the image from your cameras live. Decrease or increase the level
of sharpening by selecting: Detail off, detail default for low sharpening, medium detail and
high detail.
Color Wheel
The color wheel is a powerful feature of the DaVinci Resolve color corrector and used to make
color adjustments to each YRGB channel’s lift, gamma and gain settings. Youcan select which
setting to adjust by clicking on the three selection buttons above the color wheel.
Master Wheel
Use the master wheel below the color wheel to make contrast adjustments to all YRGB
channels at once, or luminance only for each lift, gamma or gain setting.
Reset Buttons
The reset button near the bottom right of each camera controller lets you easily choose color
correction settings to reset, copy or paste. Each color wheel also has its own reset button.
Press to restore a setting to its default state, or copy/paste a setting. Locked controllers are not
affected by the Paste feature. The master reset button on the bottom right corner of the color
corrector panel lets you reset lift, gamma and gain color wheels plus Contrast, Hue, Saturation
and Lum Mix settings. You can paste color correction settings to camera controllers individually,
or all cameras at once for a unified look. Iris, focus, coarse and pedestal settings are not
affected by the Paste feature. When applying Paste to all, a warning message will appear asking
you to confirm your action. This is so you don’t accidentally paste new settings to any unlocked
cameras that are currently on air.
Each camera controller displays the channel
status so you know which camera is on air
85Using ATEM Software Control
To Next Page
Loading...