Bosch DB18C3100R2 - Page 83

DiBos/DiBos Micro Default Configuration | en 83
Bosch Sicherheitssysteme GmbH Installation Guide F.01U.033.308 | V7 | 2009.09
Assigning AP line statuses to inputs (not for Bosch G Series)
Inputs and outputs menu > AP inputs tab > Line status section > Assign button
(see also Section 6.5.7 Configuring AP Inputs)
Assign AP line statuses to the inputs.
Adding line statuses
Removing line statuses
5 Line status - Assign Click the button. A dialog box opens, allowing you to
view and edit the default assignment of the line
statuses (see also Section Assigning AP line statuses
to inputs (not for Bosch G Series)).
Note:
Only possible for LSN alarm panels.
6 Addresses - Assign Click the button. A dialog box opens, allowing you to
assign specific AP addresses to the input (see also
Section Assigning AP addresses to inputs (not for
Bosch G Series) and Section Assigning AP addresses
(Bosch G Series) to inputs).
7 Save The entries are saved.
1 Unselected line
statuses:
Select the line status.
2 Add Click the button. The line status is added to the Selected line
statuses: list field.
5 Close Finishes the procedure. Saves the entries.
3 Selected line statuses: Select the line status.
4 Remove Click the button. The line status is removed from the
Selected line statuses: list field.
5 Close Finishes the procedure. Saves the entries.