Bosch DB18C3100R2 - Page 84

84 en | Default Configuration DiBos/DiBos Micro
F.01U.033.308 | V7 | 2009.09 Installation Guide Bosch Sicherheitssysteme GmbH
Assigning AP addresses to inputs (not for Bosch G Series)
Inputs and outputs menu > AP inputs tab > Addresses section > Assign button
(see also Section 6.5.7 Configuring AP Inputs)
Assign AP addresses (not Bosch G series) to the inputs.
Adding addresses
Removing addresses
1 From
Group:
Alarm input:
Enter the starting address in the input fields.
2To
Group:
Alarm input:
Enter the final address in the input fields.
3 Add Click the button. The addresses are added to the Selected
addresses: list field.
6 Close Finishes the procedure. Saves the entries.
4 Selected addresses: Select the addresses you wish to remove.
5 Remove Click the button. The addresses are removed from the
Selected addresses: list field.
6 Close Finishes the procedure. Saves the entries.