Brother E850TKW - Feeding Tape

Setting Up the P-touch
10
1
Feeding Tape 1
Important
• Be sure to feed tape to remove any slack in the tape and ink ribbon after inserting the tape cassette.
• Do not pull the label when the P-touch is ejecting it from the tape exit slot. Doing so will cause the
ink ribbon to be discharged with the tape. The tape may no longer be functional after the ink ribbon
discharges.
• Do not block the tape exit slot during printing or when feeding tape. Doing so will cause the tape to jam.
Feed and Cut 1
The Feed and Cut function feeds approximately 22.3 mm of blank tape, and then cuts the tape.
a Press the (Feed and Cut) button.
[Feed & Cut?] appears on the LCD.
b Select [Feed & Cut] using the or key, and then press the OK or Enter key. The message [Feeding
Tape... Please Wait] appears while the tape is fed, and then the tape is cut.
Note
To exit or cancel this function press the Esc key.
Feed Only 1
This function will eject the tape approximately 22.3 mm, resulting in a blank label sticking out of the tape
cassette. This action is recommended when using Fabric tapes, which should be cut using scissors.
a Press the (Feed and Cut) button.
[Feed & Cut?] appears on the LCD.
b Select [Feed Only] using the or key, and then press the OK or Enter key. The message [Feeding
Tape... Please Wait] appears while the tape is fed.
Note
To exit or cancel this function press the Esc key.